Bialaddin NRV

Discussion in 'Fettling Forum' started by Johnny19, Mar 7, 2021.

  1. Johnny19

    Johnny19 United Kingdom Subscriber

    Online
    Joined:
    Jul 5, 2020
    Messages:
    278
    Location:
    Liverpool
    Hi all, maybe a stupid question here. I recently replaced an NRV pip on a Bialaddin 305, and all working fine now.
    When i took the NRV out there was no rubber washer present, so after doing the job, i just put back in.
    Admittedly I had to clean some gunk from down the tube where the valve sits. Question is, should there be a washer in there?
    Cheers all......
     
  2. Fireexit1

    Fireexit1 United Kingdom Subscriber

    Offline
    Joined:
    Jun 13, 2020
    Messages:
    1,029
    Location:
    Brighton UK
    Yes - part no V33 I think - should have been in the kit ?
     
  3. Johnny19

    Johnny19 United Kingdom Subscriber

    Online
    Joined:
    Jul 5, 2020
    Messages:
    278
    Location:
    Liverpool
    @Fireexit1 Cheers, best get it fitted then. ( I have a tin of Vapalux/Bialaddin washers various sizes). Thanks again.
     
  4. Henry Plews

    Henry Plews Subscriber

    Offline
    Joined:
    Jun 23, 2014
    Messages:
    1,837
    Location:
    North Yorkshire
    Ideally yes (part number V33). I've known the washer stick to the bottom of the tube rather than the valve - perhaps only two or 3 times but it has happened - perhaps the gunk you cleaned out of the tube was the perished remains of the washer.

    Edit: crosed with @Fireexit1
     
  5. Johnny19

    Johnny19 United Kingdom Subscriber

    Online
    Joined:
    Jul 5, 2020
    Messages:
    278
    Location:
    Liverpool
    Thanks Guys, job done. All I have to do now is sort out the vaporiser as It's a very feeble light. The Tank is spotlessly clean, but while I'm at it I'll also check the Jet Cleaner assembly also......
     

Share This Page