ML98

Discussion in 'Table, Standard & Bracket Lamps (ML & FS)' started by BigStevie, Oct 4, 2019.

  1. BigStevie

    BigStevie United Kingdom Subscriber

    Offline
    Joined:
    Dec 5, 2018
    Messages:
    1,754
    Location:
    Scottish Highlands
    image.jpg
    My ML93 with its new oak base now a ML98!
     
    BigStevie, Oct 4, 2019
    #1
  2. Sellig33

    Sellig33 France Subscriber

    Offline
    Joined:
    May 15, 2017
    Messages:
    523
    Location:
    Gujan-Mestras - Gironde - France
    Very nice :thumbup:
     
    Sellig33, Oct 4, 2019
    #2
  3. JEFF JOHNSON

    JEFF JOHNSON United Kingdom Subscriber

    Offline
    Joined:
    Nov 28, 2010
    Messages:
    11,120
    Location:
    Shetland Islands UK..
    That does the job!:thumbup:
     
    JEFF JOHNSON, Oct 4, 2019
    #3
  4. BigStevie

    BigStevie United Kingdom Subscriber

    Offline
    Joined:
    Dec 5, 2018
    Messages:
    1,754
    Location:
    Scottish Highlands
    Thanks guys, not my handy work I’m afraid. The real thanks goes to Anthony!
     
    BigStevie, Oct 4, 2019
    #4
  5. ColinG

    ColinG United Kingdom Subscriber

    Offline
    Joined:
    Oct 2, 2017
    Messages:
    3,200
    Now that's a fine lamp you have there!
     
    ColinG, Oct 4, 2019
    #5
  6. Tony Press

    Tony Press Australia Subscriber

    Offline
    Joined:
    Aug 28, 2012
    Messages:
    6,988
    Location:
    Stinkpot Bay, Howden, Tasmania, Australia
    Very nice, Stevie!

    Fine work, @Anthony.

    Cheers

    Tony
     
    Tony Press, Oct 4, 2019
    #6
  7. AussiePete

    AussiePete Australia Subscriber

    Offline
    Joined:
    Nov 21, 2015
    Messages:
    2,971
    Location:
    Toowoomba Australia
    O’ I do like that, very much.
    Well done .....
    Cheers
    Pete
     
    AussiePete, Oct 4, 2019
    #7
  8. ColinG

    ColinG United Kingdom Subscriber

    Offline
    Joined:
    Oct 2, 2017
    Messages:
    3,200
    Did you have the base made or did you buy it?

    If I had a wood turning lathe I could make these without too much bother - and it'd be fun!
     
    ColinG, Oct 4, 2019
    #8
  9. Tony Press

    Tony Press Australia Subscriber

    Offline
    Joined:
    Aug 28, 2012
    Messages:
    6,988
    Location:
    Stinkpot Bay, Howden, Tasmania, Australia
    @ColinG

    If you read through the thread you will find the answer to your question...

    Tony
     
    Tony Press, Oct 4, 2019
    #9

Share This Page