That looks to be a nice condition Optimus 1200 from the 1960s. Not rare but desirable. Probably more so on your side of the pond. We don't do...
The light brand one looks to be missing the inner top, so give it a miss. The Petromax looks complete even though it has been fitted with a light...
It will screw into the cleaning rod, but I believe the needle is too large a diameter. I havn't checked myself.
The Primus 1020 has an inner cone fitted to the outer hood. The idea is to direct the hot exhaust gases to the vents in the hood. Primus...
I've made a couple of measurements and can see that the washer needs to be OD 12mm, ID 8mm and between 1.5 and 2mm thick. I've used lead a few...
Fogas in Sweden has the washer for the tank fitting here. It's part number 119-49. The washer for the vapouriser should be part number 119-05. I'm...
The washer should be flat and fit between the thread and the raised ridge in the centre of the block. I'm at work now but can measure one when I...
@Matti Kucer The second picture you show is of a Primus 1020 tank, so not relevant for the 119 fettle. @Stovie21 The only thing that should be...
I'm not sure you did. The fact that there is no "PAT PEND" stamp on the top of the tank would indicate that it matches with the first of the 3/300...
If you are looking for this exact part from the older 1020s (mixing tube screws onto the burner), then it might be a bit difficult. I know I don't...
Basically the only difference is the size of the jet (and needle) and the restrictor in the air intake. There are a few more differences, but they...
I've never seen that stamp before either. Now we need to see more examples. :) The lamp looks like what I would call the second variation of the...
Nice project Matti. Good luck with the fettling. The filler cap is from a Primus. The correct type is the same as was fitted to the 930. The...
That chimney is described as a Pyrex "Matador" chimney and according to the Aladdin book is "1974 - 1977 Pyrex Matador Chimney for commemorative...
No they are not the same. The part number for the quick starter on the 1321 (and 1381) is 6022. The channels in the housing are different to allow...
Now that is a very nice find. Well done. I can't help but be a bit jealous.
@Buggerlugs Have you tried clear lacquer? A lot of the Tilley and Kayen lamps were lacquered brass rather than paint.
They are not in a 1975 catalogue but are in a 1979 price list, so they started somewhere in the late 1970s. The later version of the 1200M with...
The 703 had a non regulating burner number 205R (the R is for radiant heater). The 7703 had a regulating burner number 207R. These heater burners...
These late 1930s 119s with the early 1930s filler caps are unusual. They do turn up now and then, so must have been a production run for some...
Separate names with a comma.
