Well The Fire gods made me do it Found the seal and Leather Tested the NRV after some wd40 - Seems all is good So here we go Tightened...
Greetings Well a little progress Managed to gently remove the Burner This revealed a beaut of a find [ATTACH] Lessons learnt from a...
Correct reflector orientation I take it the controls are behind the reflector - It seems that would keep heat on the 70 % of the fount - Saving...
Here A little gem found yesterday Was collecting the Post vice [ATTACH] when this jumped out of the darkness [ATTACH] [ATTACH] [ATTACH]...
Phred I like the flames near flammable Living on the edge :lol: Just remember Fire extinguish measures Usd thd correct equipment Water is...
Phred Dremmel a channel on the hair line crack Plus soft solder with lead
Let the Fettle Free Apart from a wee pin hole on the fount Plus a lesson learned on the pickup Plus 2 mantles later [ATTACH] All the shiny...
A fellow member passed me this opportunity Phill you are a legend So here as hatched [ATTACH] There could be a few pitholes Will strip...
Yes Jeff I shall fading a wall fitting as a holder :lol:
Managed to get the wick inserted Pre heated with a butane torch and we have life Next to get some kind of mantle up there Sure this will...
[ATTACH] This was as I stripped Found the pic I cannot remember if there was wire / "fork" inside Seems a similar settup to a Svea wick ?
Thanks Wim So if I understand Wire up the top of the wick stands and cover the whole lot with some gauge mesh The fork you reference Is this...
Greetings Not quiet pressure stuff Yet an interesting project [ATTACH] Seems this baby had been on display for many moons Post strip down...
Greetings All Today I was fixing a Beatrice stove Now we all know that mica screen is the first bit that gets poked out I managed to save...
Andrew Looks like half of thd Karoo was camping in that lamp :lol: Nice job buddy Another one saved Well done
Here is the parting shot This was this morning when our power company of the country decides to share our electricity with supply The...
Thanks all Today I just straightened the gennie tube a few degrees in This as the vapour was not entering the burner tube correctly Only...
So this am it was back to the drawing board In my haste I believed the butterfly inner would work Hell no ! So copied the Radius innards...
Well after plenty stuggles With getting the flame to burn properly Decided to put on the Radius hood [ATTACH] And there we go it lights the...
So we all together Other issue was the usual sheared off nrv So some heat to get the pump tube out Drilled out thd naughty piece and replaced...
Separate names with a comma.
