Any contact info for these ? Thanks !
Good idea ! When I order the rebuild kit for the second lantern I'll send for 350 jet as well. Thanks !
Won another Amish Petromax on the 'bay.... After my trials with the first one...you'd think I'm a glutton for punishment..this one made it here...
It is such a tiny hole that is leaking... I'm hoping that I can wire brush it a bit...flux it and hopefully the reheat..once the solder flows...
So I have this Amish Hipolito (another thread) that has a leak due to a previous dodgy soldering job: [ATTACH] I can sweat copper pipe just...
Slowly making progress... I changed the jet and sealed it with some "muffler cement" and adjusted the the mixing tube up to 500cp specs from the...
Okay. All generators are exactly the same size, height and diameter... This picture should pretty well illustrate what's going on with the...
I'm really quite hesitant to try a run with white gas .....after the flame-out.... :shock:
Well....as of right now ?...... She's a better looker than a runner.... After a nice citric acid bath and some polishing...she's a beauty...new...
Today was a good day...with a little bit of patience the NRV came out. Luckily the pricker rod is still nice and straight in spite of the bend in...
I recently bid and won this lantern on the 'bay: [ATTACH] I bid low and won - so I figured it might make a nice project... unfortunately the...
Well. I'm glad (and proud) to say....she's up and running. Followed the lighting instructions as found on the web and it worked perfectly. Had...
Well....as it goes along...there's always good news and bad news 'eh ? So..the good news... Ended up stripping the fount: [ATTACH]...
So I finally got my first Bialaddin.... Posting pics to let the pros take a look at it to: notice if there's anything glaring missing or needed...
Sadly..... Still pulsing ](*,) I purchased and installed a new vapourizer with new cleaning wire off the 'bay from hootflipflopandfly....
Okay. Cleaned the fuel tube as requested. (re)Cleaned control cock. One unfortunate thing is the service pack rubber "pads" for both the pump...
I would put my bets on the vapouriser. If I pressurize the tank and remove the hood cap - then open the control valve (which I did tighten down...
Hey All, Picked this fellow up of the 'bay for a song. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Missing some parts:...
Thanks for the info Jeff, Interesting posts - I did read them all. Thanks Again ! Dan
Hello and thanks for the reply. Nothing on it anywhere except stamped on the bottom (last picture) "Made in England" and the letter "P". Chrome...
Separate names with a comma.
