While I wait for the seals to arrive, is there a good source for the ceramic insulator and the wire mantle?.
I'm impressed by the ingenuity, it works a treat, it now pressurises but I it leak at the control tap now where the picker contol is, do I need to...
Thanks for the diagram Henry, I seem to be missing the valve spring then.
Hello again all!, after a long hiatus I'm back on the R55 project, I have replaced all the seals in pump but I don't if it is kaput or if may have...
Yes that is the washer, I'll give that a try and will report back when it have got it sorted
I believe it is an R55 as the fuel tank is quite large, any ideas on how to get the damaged washer out it on the fitting where the pump system...
I'm not sure it is a gauge on side of the tank, it being the fuel gauge would make sense, I believe the tank is made out of steel with a mettalic...
Hello all I have replace the seals in the pump bar one which is damaged but it still holding on for dear life and I am unable to get it out, the...
Hello all, I have recently (Tuesday) got an old Tilley Heater, I have taken it a part and it needs new seals and pump needs the leather cup, I...
Well Gentlemen, I reckon this is it, I had to replace the Vapouriser as even with attempting to revive it still didn't work correctly, The mantle...
@Fireexit1 I've tried again at 50 pumps, the tank isn't full it's about half full, it worked a bit better than last time but still poor should I...
Hello everyone I think it has failed the mantle, I don't think the mantle burned correctly it doesn't light up at all really just a couple spots...
@@steerpike451, The pop wasn't the vapour lightning it was more than it and only the first time so I think I did a poor job of clearing the burner...
@Gary Waller, as this my first Lamp I haven't got another lamp and I dont know of any locally I could borrow, I did hear a kind of light...
@JEFF JOHNSON Thank you I wasn't sure of the amount pressure required.
@podbros, I've tried the burn test I probably put far too much Methalyated Spirit in the cup and wick!, I also think I pumped to much before she...
pb, Yes I thought that I might as well replace the rest of the seals. As for the burner I blew the dust out of it anything else that needs done to...
pb, problem was I put the NRV washer in the wrong place sorted it and replaced the rest of the seals and there was not a bubble here, there or...
pb, I've done the test and there seems to be a couple the 1. The Pump which had a steady stream of bubbles 2. The Filler cap but it near enough...
pb, I tighten her up and the pump is working as intended but she won't hold pressure she seems to he failing at the control area and when I put...
Separate names with a comma.
