Should I keep it installed? I'm going to burn only kerosene.
Thank you, that was very helpful. Does this filter need to remain in the B carburetor? [ATTACH]
The lower half of my mantle has turned black, maybe that's what's causing the flaming. Edited to add: the crack in the nut was only superficial,...
I stopped the leak with an o ring, but now it's flaming like in the picture. What could be causing this?
I found the leak. It's coming from the valve stem nut. It looks like it's cracked and when I open the valve, fuel seeps out from the bottom of the...
It's possible I installed the foot valve incorrectly. I'll post pictures of it once I have it apart again. I'm still waiting for it to cool.
I will check the foot valve seal next. Why would the foot valve seal cause it to leak when the needle is down? I did replace the foot valve seal...
I'm going to use permatex high temp thread sealant on the jet nut. It can only withstand temperatures up to 400F. Is that enough?
It's hard to tell though. I don't know how it could be leaking for there. It could be coming form higher up.
@MYN I stopped it leaking from the pre heater. It's still leaking from somewhere in the valve/carburetor. It looks like it's coming from this...
Could this carbon cause any issues? [ATTACH]
I don't have on of those, so that's not an option for now. I did dunk the pressurized tank into water. I saw a leak at part #221 (rapid jet...
Lighting: Pressurize to 2 bar, ignite rapid. Let burn for about 1 minute, open valve while rapid is lit. Close rapid. I'm going to dunk the tank...
I'm going to check the spray pattern from the jet once it cools down. Since it only leaks when I open the valve, there might be a problem with the...
Are you saying it's normal for the lantern to leak some fuel when the rapid is burning? So not all the fuel that is being released is being...
Only leaks when needle is down or rapid is burning/open. [ATTACH] [ATTACH] [ATTACH]
I double checked and cleared the holes again. The fuel hole was clogged, I missed it earlier. Now I have a couple more problems. The tank holds...
Fuel vapor is visibly shot into the cage from the rapid. When I cleaned it, I didn't notice any clogs and I could see light through all the small...
I noticed leaking around the seal of the rapid pre heater. I must not have tightened it down all the way. The good news is can loosen the rapid...
@Dashwood I replaced the sealing pip earlier. I remembered I re used the hex nut the top of the generator. I replaced the nut and the leaking...
Separate names with a comma.
